• Automatic: self closing with adjustable pause time by means a trimmer;
• Half-automatic or step-to-step: with different motion commands for opening and closing.

Programmation phases:
The programmation occurs with self-learning at the end of the installation, after the setting of few parameters, according the installation notice.


Main characteristics:

• Output for 1 or 2 motors of 12Vdc with max power of 70 Watt each;
  
  
• Possibility to put the outputs into parallel configurationfor a single 12Vcc/140W motor;
  
  
• Outputs [All the outputs are protected against the short-circuit and the over-currents]:
  - Warning light 12Vcc/50 Watt [internal self-blinking];
  - Electric lock 12Vcc/60 Watt;
  - Power supply for the auxiliary devices (infrared photocells, etc.) 12 Vcc/0.5 A;
  - back-up battery with internal battery charger. The battery assures, without mains at least 10 operating cycles. The average battery charge is 5 years.
  
  
• Inputs [All the inpouts are protected against over-voltages]:
  - N.O. button with programmable pedestrian opening;
  In the pedestrian configuration the single shutter is opened for about 1 meter and closes automatically after 5 sec.;
  - N.C. contact for safety photocells of re-opening;
  The contact activation, during the pause, resets the pause time;
  - N.C. contact for safety photocells of stop; the same contact can be even used as limit-switch.
  
  
• Operating functions :
  - Slowing down near the limits, in programmable with self-learning;
  - Operating time in programmable with self-learning;
  - Motor supply cut-off in case on obstacle presence with programmable treshold level;
  - Motion inversion escludible during the opening ( programmable );
  - Motion inversion during the closing for an obstacle presence ( programmable ).
  
  
• Receiver card :
  Included. Receiving frequency 433,92 MHz or 30,875 MHz;
  Self-learning of the transmitter codes ( when a fixed code transmitter is used ).